Operation
The gear drive that is
attached to one end of the
Axle supports has a safety
lock. The safety lock is
designed that it can be
swung out to operate or
swung-in when not in
operation. Disengage the
safety lock out by inserting
Winding pole hook into the
lock slot and pulling away
from gear loop.
17
Place the Winding pole
through loop on the gear
drive. When operating, the
platform must have weight on
it. Place at least 25lbs of
weight on the platform and
slowly lift the platform. The
cables should evenly wind
around the Axle and not
overlap. The platform should
be raised such that the stored
items are not touching the
ceiling or the Axle. The platform will lower
approximately 8 feet from the ceiling.
Note: If cables do not wind evenly, be sure cable
ring is pushed all the way in.
Also make sure the load is balanced and the
platform is level.
18
Optional Drill/Driver Adaptor
GOOD
BAD
Assemble Winding
pole to Hand-crank
for manual operation or
Drill/Driver for powered
operation, using the
provided screw and nut .
16
I
J
K
L
