Assemble and install
axles and cable
assemblies
Slide together the
Axles but do not
assemble with screws yet.
The bolt holes should be in
line.
9
G
H
Slide each cable assembly ring
over the square shoulder at each end of Axle ,
as far as it will go. The cable assemblies should be
placed on the square portions of the Axle and the
cable ends should face towards the center.
10
A
G
H
Secure the Axle by
installing fender washer
and hex screw on the
end of the gear drive. Then,
insert the provided cotter
pin through a hole on the
other end and secure it by
bending the two protruding
ends.
12
P
Insert one end of the Axle into
the Axle Support and slide them
apart to insert the other end. The
square end should fit into the gear
drive and the round end should fit
into the plastic bushing.
Fasten the Axle ends together with
two screws and nuts .
11
O
