注 意 : 本送帶機必須使用下列規格的針板。
ATTENTION: THIS METERING DEVICE MUST BE OPERATE WITH THE FOLLOWING TYPE OF NEEDLE PLATE.
二: 放入鬆緊帶的正確位置:
2: THE RIGHT POSITION FOR INSERTING ELASTIC TAPE:
01
NO.MCA20K-02
20150417
錯誤
W rong
W rong
Correct
四線包縫車用
三線包縫車用
正確
錯誤
O NE NEEDLE OVERLOCK
TW O NEEDLE OVERLOCK
Rear
& Fro
nt
Rig
ht &
Le
ft
The adjustable screw for m ain base
The center of inserting slot of presser
foot should m eet the red m ark.
Presser foot
The air jet hole for
feeding tape
Red m ark
Elastic tape
PLANE FIG URE
鬆緊帶
平面圖
紅點
送帶吹氣孔
壓布腳
對準壓布腳入帶口的中央
紅點 (下方為吹氣孔)
Red mark (The air jet hole is under the red mark
鬆開螺絲可調整主基座的位置
左右
前後
Side Close
外側封閉
Two Row Teeth
兩排送齒
單排送齒
O ne Row Teeth
外側開放
Side O pen
Correct
正確
W rong
錯誤
錯誤
W rong
Side Close
外側封閉
Two Row Teeth
兩排送齒
單排送齒
O ne Row Teeth
外側開放
Side O pen
必需調整主機的紅點對準壓布腳入帶口的中央。
(送帶用吹氣孔是在紅點的下方)
Make sure the center of inserting slot of pressure foot should
meet the “RED” mark (The air jet hole is under the “RED” mark.)
