Race RC Velocity 800 BL, Instruction Manual

Page: 13 / 16

13
Rudder does not move
Motor power pulses
then motor loses power
Rudder,linkage or servo damaged Replace or repair damaged parts and adjust
controls
Wire is damaged or connections are
loose
Do a check of wires and connections, connect
or replace as needed
Transmitter is not bound correctly or
the incorrect model was selected
Re-bind or select correct model in transmi tter
BEC (Battery Elimination Circuit) of the
ESC is damaged
Replace ESC
ESC switch is off Power on ESC switch
Controls reversed Transmitter settings are reversed Do the Control Direction Test and adjust controls
on transmitter appropriately
Motor or ESC overheats Blocked water cooler tubes Clean or replace water tubes
ESC uses default soft Low Voltage Cut-
off (LVC)
Recharge boat battery or replace battery that is
no longer performing
Weather conditions might be too cold Postpone until weather is warmer
Battery is old, worn out or damaged Replace battery
Battery C rating may be too small Use recommended battery
Replacement Parts List
Need spare parts? Contact y our local hobb y shop or place of pu r chase. If un available, contact Rage RC direct at
Item Number Description
RGRB1208 Velocity 800 BL Deep Vee RTR
RGRB1262 Painted and Decorated Hull; Velocity 800 BL
RGRB1263 Painted Replacement Canopy: Velocity 800 BL
RGRB1264 Canopy Latch (2); Velocity 800 BL
RGRB1265 3536/1800KV Brushless Motor; Velocity 800 BL
RGRB1266 Brushless Motor Coupler; Velocity 800 BL
RGRB1267 60A Brushless ESC (Water-Cooled); Velocity 800 BL
RGRB1268 Stainless Steel Rudder; Velocity 800 BL
RGRB1269 Rudder Push Rod (2); Velocity 800 BL
RGRB1270 Stainless Steel Shaft Bracket; Velocity 800 BL
RGRB1271 Running Hardware Set; Velocity 800 BL
RGRB1272 Prop Shaft w/ Prop; Velocity 800 BL
RGRB1273 Teflon Shaft Tubing; Velocity 800 BL
Stainless Steel Propeller (3); SC700BL, Velocity 800 BL
RGRB1257