Assembling your machine
1. Assembling the detergent tank:
a. Connect the soft hoses to joint of
detergent
tank.
(Dia
1)
WARNING: Do not adjust the nozzle while
the trigger is squeezed.
The pressure of the spray on the surface
you are cleaning increases as you move
the nozzle closer to the surface. We
recommend that for most cleaning
applications a 45
o
spray angle should be
used to avoid damage to surface being
cleaned. Spraying directly head-on tends to
cause dirt particles to embed in the surface.
The turbo lance is a fixed nozzle, which
effectively increases the area of the high
pressure water jet , and decreases the time
required to clean larger areas like patios.
The turbo nozzle provides a circular water
pattern as it sprays high-pressure water. The
spray pattern on this nozzle is not adjustable.
The circular spray action does heavy cleaning
in less time.
The spray is adjustable from a pencil jet
spray to fan spray by tuning the nozzle
shown (Dia 9).
Fully open the tap on the water supply.
Before turning the unit on, press the gun
trigger to bleed any trapped air out of the
pump and hose. Start the pressure washer
by turning ON/OFF switch to ON position,
and press the trigger to spray water.
REMINDER:
Motor does not run continuously,
only when trigger is squeezed.
WARNING: When taking a break, engage
gun safety lock (Dia 8) and switch off. If left
too long the temperature of the water in the
machine will increase quickly and could
damage the pump.
Never operate your pressure washer
without the water supply on.
Note:
Before connecting to mains supply please
ensure that your pressure washer is
switched OFF (Dia 7)
Then connect to mains supply and water
supply.
Instructions for use
Helpful Hints
Before starting any cleaning, remove any
objects, which could create a hazard.
Ensure that all doors windows are closed
(where appropriate).
The adjustable Lance allows you to use a
variety of spray patterns from a fan to a
pencil jet. When using the pressure
washer to clean decking, patios, vehicles
etc. Always start by using the fan spray and
begin spraying from a minimum 30cm away
to avoid damaging the surface of the
material to be cleaned.
Assembly
Operating Instructions
-4-
-5-
b. Assemble the detergent tank as in ( Dia 2 )
and screw together using 3 off Item 13 in
components
diagram.
2. Assembling the high pressure hose:
a. Connect the high-pressure hose to the outlet
(Dia
3)
b. Connect the high-pressure hose to trigger
gun, use spanner to tighten the connection.
(Note, always use two spanners to tighten the
connection, but do not over tighten). (Dia 4)
3. Assembling the lance and trigger handle:
a. Push the Lance into the trigger handle locating
the lugs at the same time, then turn Clockwise
to lock into position. (Dia 5)
(Note do not fit lance when power is on).
4. Connecting the water supply
b. Always remove or replace parts whilst the
high
pressure
cleaner
is
switched
off.
1. Connect the female connector of your garden
hose onto the male connector of your high
pressure cleaner. (Dia 6).
NOTE:
Before carrying out any assembly or disassembly of the unit please ensure that the unit is not
connected to the electrical supply.
Dia.1
Dia.2
Dia.3
Dia.4
Dia.5
Dia.6
Dia.9
Dia.7
OFF
ON
Dia.8
LOCK
OFF
LOCK
ON
