User’s Manual
71
Reads the calibration constants, gain, and offset for an input based on its designated channel code
position into global table
_adcCalib
. The constants are stored in the top 1K of the reserved user
block memory area. Use the sample program
USERBLOCKINFOR.C
in
SAMPLES\OP7200
to get
the addresses reserved for the calibration data constants and the addresses available for use by your
program.
NOTE:
This function cannot be run in RAM.
PARAMETERS
channel
is the analog input channel number (0 to 7) corresponding to AIN0–AIN7:
opmode
is the mode of operation:
0
=
SE_MODE
—single-ended input line
1
=
DIFF_MODE
—differential input line
2
=
mAMP_MODE
—4–20 mA input line
gaincode
is the gain code of 0 to 7 for both single-ended and differential measurements:
int anaInEERd(unsigned int channel, int opmode,
unsigned int gaincode);
channel
Single-Ended Input
Differential Input
0
+AIN0
+AIN0 -AIN1
1
+AIN1
—
2
+AIN2
+AIN2 -AIN3
3
+AIN3
—
4
+AIN4
+AIN4 -AIN5
5
+AIN5
—
6
+AIN6
+AIN6 -AIN7
7
+AIN7
—
-1
ALL_CHANNELS
ALL_CHANNELS
Gain Code
Macro
Gain
0
GAIN_X1
×1
1
GAIN_X2
×2
2
GAIN_X4
×4
3
GAIN_X5
×5
4
GAIN_X8
×8
5
GAIN_X10
×10
6
GAIN_X16
×16
7
GAIN_X20
×20
Summary of Contents for eDisplay OP7200
