RAB STEALTH STL360 Instructions Manual Download Page 7

Page: 7 / 12

INSTRUCTIONS

STEALTH STL360 INSTALLATION

RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install

and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]

STL360 KIT ASSEMBLY AND WIRING (

cont’d)

Multiple Sensors

Multiple sensors may be wired together, but doing this will make

problems diffi cult to troubleshoot. Single sensors that control their

own lights will give a more accurate location of movement and
trouble-free operation.

Multiple Fixtures

Multiple fi xtures may be wired to a single sensor. To handle loads
greater than 1000 watts, a qualifi ed electrician should install a relay

as shown in Fig 19.

Fig: 19

Power Quality

It is not recommended to install sensors on a circuit that also feeds
motor loads such as HVAC equipment, kitchen appliances, or ga-
rage door openers. The Stealth circuit is surge and transient voltage
protected.

However, if voltage varies signifi cantly from 120V, the sensor may

malfunction. This may occur on circuits with motor loads.

Fig: 21

Fig: 22

Fig: 20

Photocell

For night-only operation, turn the knob completely
counterclockwise to the

MOON

symbol. For 24-hour operation turn

the knob all the way clockwise to the

MOON/SUN

symbol.

Adjust counterclockwise to have the sensor come on later at
dusk, clockwise to have it come on earlier. The Factory Setting is
Night-only

(MOON)

. If you set Evening Timer while set to 24 hour

operation, Evening Timer will begin immediately after fl ipping

switch as shown in Fig 21.

Evening Timer

The STL360 provides an alternative to normal motion-activated
lighting. The EVENING TIMER as shown in Fig 22 can keep lights
on continuously without motion detected for 1 to 8 hours after
dusk. This is great for evening activities requiring continuous light.
During vacations the EVENING TIMER provides a “lived-in” look by

simulating an occupant turning lights on at dusk, and then off at

bedtime.

Sensitivity

Increases or decreases the responsiveness and range of the
sensor

(adjustable from 30% to 100%).

The Factory Setting is

100% as shown in Fig 22.

Time

Sets the time that lights will remain on after the detection zone is

vacated. Adjustable from approximately 5 seconds to 12 minutes.
The factory setting is 12 minutes as shown in Fig 20.

ADJUSTING STL360 SETTINGS (

cont’d)