INSTRUCTIONS
STEALTH STL360 INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
IMPORTANT
CAUTION: TURN OFF ALL POWER AT CIRCUIT BREAKER/FUSE PANEL.
• Read entire Installation Manual before proceeding.
•
All wiring should comply with local electrical codes and requires a qualified electrician.
• The total lighting load connected to STL360 must not exceed (1000W Incandescent, 250VA Standard Ballast
400VA Electronic Ballast (LED).
To switch more wattage, an electrician can install a relay.
• Line Carrier Remote Control Systems such as X-10, Leviton or Radio Shack are incompatible with sensors and may
cause false activations.
• Do not install sensors on a circuit that feeds motor loads such as kitchen appliances, HVAC equipment, washer/dryer,
or garage door openers.
• Sensor functions best when the direction of expected movement is across its detection pattern, not towards the sensor.
• Mount 6’-10’ high for optimum range and detection.
WARNING: RISK OF ELECTRICAL SHOCK
•
Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
•
Verify that the supply voltage is correct. Connect fixture to a 120V, 60 Hz power source.
• Make sure all electrical and grounded connections are in accordance with the National Electrical Code and any applicable
local code requirements.
• All wiring connections should be capped with UL listed wire connectors.
SPECIFICATIONS
CONTENTS OF ACCESSORY KIT
STEALTH STL360
Switching Capacity:
8 amps @120V
1000W
Incandescent
250VA
Standard
Ballast
400VA Electronic Ballast (LED)
Voltage:
120V
Protection Pattern:
180
°
forward
360
°
below and to the sides
Time Adjustment:
5 seconds to 12 minutes
Power Consumption:
1 watt
Surge protection:
6000 volts
•
2 Lens Masks
•
Indoor Switchplate Label
•
3 Wire Nuts
•
Adjustment Tool
•
Mylar Lens Mask
•
Crossbar with Green
Ground Screw
•
Hanging Hook
•
1/2” Close Up Plugs
(3)
•
Slotted Screws
(4)
•
Finishing Cap
•
O-ring Gasket
•
Center Mounting Screw
•
Metal Surface Mounting Plate
with Gasket