![background image](http://html1.mh-extra.com/html/rab-lighting/wpled26dc/wpled26dc_installation-instructions_3122861003.webp)
WPLED20DC INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT.
WARNING:
Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
Thank you for buying
RAB LED lighting.
Comments? Call us at
888-RAB-1000, or email:
JuNcTION bOx MOuNT fOR
cONduIT
For use on applications where conduit wiring is needed.
1.
Loosen and remove (4)
Lens Screws
. Remove
Door
.
2.
Loosen and remove (2)
Housing Screws
. Remove
Housing
from
Back Box
. Keep
Housing Gasket
intact
for re-assembly.
3.
Secure
Back Box
to the mounting surface using
hardware appropriate for that mounting surface.
4. Wire the fixture using UL listed wire connectors
according to NEC and local codes. Apply sealant to all
unused conduit entry points.
5.
Place
Gasket
between
Back Box
and
Housing
.
Re-mount
Housing
to
Back Box
. Check
Housing
Gasket
seal all around the
Back Box
.
6.
Re-mount
Door
to
Housing
. Tighten (4)
Lens Screws.
Check door gasket (not shown) seal.
7.
Fixture can be mounted in a downlight or uplight
position. Fixture may not melt heavy snow accumulation
in an uplight position.
CAUTION: For proper weatherproof function all
gaskets must be seated properly and all screws
inserted and tightened firmly.
Lens
Screws
Junction Box
Surface Mount
Back Box
Housing
Gasket
Housing
Door
Housing
Screws
suRfAce MOuNT fOR Recessed
JuNcTION bOx
For use with recessed junction box and wiring.
1.
Mount
Surface Plate
to fixture with
(4)
Surface Plate
Screws
. There are two screws from the front and two
screws from the back. Make sure
Housing Gasket
makes complete seal all the way around.
2.
Use supplied crossbar. Mount
Crossbar
to recessed
junction box with (2) screws.
3.
Place
Junction Box
Gasket
on back of the fixture.
Gasket should create seal against mounting surface.
4. Wire fixture to supply wires in recessed junction box
according to wiring section.
5.
Use 1/4 x 20 stainless steel
Mounting Screw
to attach
fixture to Crossbar. Tighten
Mounting Screw
.
6.
Cover screw with
Cap,
provided.
7.
Fixture can be mounted in a downlight or uplight
position. Fixture may not melt heavy snow accumulation
in an uplight position.
CAUTION: For proper weatherproof function all
gaskets must be seated properly and all screws
inserted and tightened firmly.
Crossbar
Junction
Box Gasket
Mounting
Screw
Cap
Recessed
Junction Box
(not provided)
Surface
Plate
Housing
Gasket
(4) Surface
Plate Screws
fIxTuRe MOuNTINg
To ensure weatherproof seal, apply weatherproof silicone sealant around the edge of the
Housing
and/or
Back Box
. This
is especially important with an uneven wall surface. Silicone all plugs and unused conduit entries.