VAN1LED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
VAN1LED-IN-1016
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2016 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly [email protected]
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation
or maintenance.
TAMPERPROOF SCREWS
RAB Vandalproof fixtures are shipped with both standard
and tamperproof screws. For maximum security, insert
tamperproof screws into the refractor and tighten with
Center Pin Torx Screwdriver. (Catalog # Vandriver, not
supplied)
WIRING
USE SUPPLY WIRE RATED FOR 90ºC.
1.
Connect the line (+) fixture lead to the black supply lead.
2.
Connect the common (-) fixture lead to white supply lead.
3.
Connect the GROUND wire from fixture to supply ground.
4.
All unused leads must be capped and insulated.
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Be sure the fixture is grounded properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1.
Clean polycarbonate lens with non-abrasive cleaning
solution.
2.
Do not open the fixture to clean the LEDs. Do not touch
the LEDs.
MOUNTING TO THE OPTIONAL
VAN1BB BACK BOX
1.
Attach conduit to desired conduit entrance(s) in
VAN1
BB
Back Box
.
2.
Loosen
Tamperproof Screws
to remove
Refractor
from
Mounting Plate
.
3.
Secure
Back Box
to surface using proper hardware.
4.
Feed supply lines through
Mounting Plate
Gasket
and
Back Box
and make necessary wiring
connections.
5.
Align
Mounting Plate
with
Mounting Plate Gasket
and secure to
Back Box
by tightening
O-Ring and
1/4-20 Bolt
into offset hole in
Mounting Plate.
6.
Secure
Refractor
back onto
Mounting Plate
by
tightening provided
Tamperproof Screws
.
AC Board
Mounting
Plate
O-Ring and
1/4-20 Bolt
Tamperproof
Screws
Refractor
Mounting
Plate Gasket
VAN1 BB
Back Box
Supply
Wires