Caution
•
All wiring MUST comply with local
electrical codes and should be installed
by qualified electrician.
•
Read entire Installation Manual before
proceeding.
TURN OFF POWER BY REMOVING
POWER FUSE OR TURNING OFF CIRCUIT
BREAKER BEFORE INSTALLATION.
• Total lighting load must not exceed:
500W LED BULLET12 at 120 Volts
5 Amps, 450 Watts LED at 120 Volts with
..
0.8pF driver
5 Amps, 300 Watts LED at 120 Volts with
..
0.5pF driver.
To switch more wattage, an electrician
can install an additional relay.
• Line Carrier Remote Control Systems
such as X-10, Leviton or Radio Shack are
incompatible with sensors and cause
false activations.
• Do not install on circuits feeding motor
loads such as kitchen appliances, HVAC
equipment, washer/ dryer or garage door
openers.
• Sensor functions best when movement is
across its detection pattern, not towards
the sensor.
• Mount 6’-10’ high for optimum range and
direction.
Less Sensitive
More Sensitive
Mounting
1. Attach the
Universal Mounting Bar
with the screws provided to the
Junction
Box
. In case of surface mount junction box, use with the
Metal Surface Plate.
For
proper weatherproof seal, apply weatherproof silicone sealant around the edge of
the Junction Box. This is especially important with an uneven wall surface.
2. Use the ‘S’ shaped hands free
Hanging Hook
to hold the
CU4 Plate
during wiring.
3. Bring power leads and BULLET12 head leads into
Junction Box
.
4. Strip off atleast 1/2” of insulation from all leads, and insert through openings in
Metal Surface Plate
(if used).
5. Attach ground wire to grounding screw on
Junction Box
. Complete wiring as
shown in wiring diagram section.
6. Align
Gasket
,
CU4 Plate
and
Metal Surface Plate
(for use with surface mounted
junction boxes) to ensure proper seal.
7. Tighten
Center Screw
(make sure
O-Ring Gasket
is on the screw) to attach
CU4
plate
to the box. Check that the
Gasket
is fully sealed.
8. Insert plastic
Finishing Cap
in the center of the
CU4 Plate
for a weatherproof
seal. Use silicone sealant on all plugs and unused conduit entries.
9. Aim BULLET12 heads in the desired direction and tighten locknut and arm screw.
5
4
Assembly and Wiring
Two BULLET12 heads come pre-wired
and assembled along with SMS500
sensor on CU4 plate, allowing for
mounting on round, rectangular or
octagonal surface or recessed boxes.
1. Connect the black fixture lead to the
(+) LINE supply lead.
2. Connect the white fixture lead to the
(-) COMMON supply lead.
3. Connect the GROUND wire from
fixture to supply ground.
4. Red pigtail is only used to switch
remote or additional fixtures.
Black
Black
Red
Red
(pigtail)
Ground
Ground
Power In
White
White
O-Ring Gasket
CU4 Plate
Gasket
Plug
Center Screw
Finishing
Cap
Metal
Surface
Plate
Hanging
Hook
Universal
Mounting
Bar
Bar
Screws
Junction Box
(not supplied)
.
