LOTBLASTER 65W 110W 160W INSTALLATION
INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
™
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2016 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly [email protected]
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during
installation, operation or maintenance.
LOTBLASTER 65 110 160 IN 1216
Pending: Patent pending
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Be sure the fixture is grounded properly.
3. Ensure the photocell, if used, is functioning properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1.
Lens should be washed in a solution of warm water and
any mild, non abrasive household detergent, rinsed with
clean water and wiped dry.
2.
Do not open fixture to clean the LED. Do not touch the
LED.
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru
277V, 50 or 60 Hz. 0-10V control wires must be rated for 300V
minimum. Units ordered with (/480/D10) suffix operate at
480V, 50Hz/ 60Hz. Follow the wiring directions as shown in
figure below.
1.
Connect the black fixture lead to the LINE supply lead.
2.
Connect the white fixture lead to the COMMON supply
lead.
3.
Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to
the output.
4.
Connect the purple fixture lead to the (V+) DIM lead.
5.
Connect the gray fixture lead to the (V-) DIM lead.
6.
Cap the yellow fixture lead, if present. Do NOT connect.
BILEVEL DIMMER OPTION
For 100% light output (disabling the dimmer), splice red wire
with black line wire.
For chosen output only, leave red wire capped.
For Bilevel Function, connect red wire to switched device.
Determine what % light output is desired and set switch prior
to installation. Options are: 25%, 50%, and 75%.
RECEPTACLE OPTION
Units ordered with (/PCT) suffix is supplied with 3 wire
receptacle and 120-277V Twistlock Photocell. Units
ordered with (/PCT4) is supplied with 3 wire receptacle
and 480V Twistlock Photocell.
Units ordered with (/5PR) suffix is supplied with 5-Pin
receptacle without photocell. Units ordered with
(/7PR) suffix is supplied with 7-Pin receptacle without
photocell. Brown and Orange wires from the 7-Pin
receptacle are not connected and are reserved to DALI
or other control systems.
