Fixture should not be recessed.
LOCATION
FLEX FLOOD
Wall Mount Installation Instructions
WIRING
All units are factory wired for 120v. If voltages other than 120V are
required, Remove the reflector and rewire for the appropriate voltage.
1. Connect the appropriate BLACK fixture lead to the
(+) LINE supply lead.
2. Connect the WHITE fixture lead to the (-) COMMON
supply lead.
3. Fixture ground wire must be connected to supply ground.
4. All unused leads must be capped and insulated.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and and all applicable local codes. Proper grounding
is required for safety.
WARNING:
MAKE CERTAIN POWER IS
OFF
BEFORE INSTALLING OR MAINTAINING FIXTURE
LAMP INSTALLATION
Caution:
Prior to installing, check that the lamp is of proper type and wattage. Observe lamp
manufacturer’s recommendations on lamp operation, ballast type and burning positions.
1. Disconnect power. Make sure fixture and lamp are cool enough to touch.
2. Open fixture by removing the 4 door screws. Swing lens door down on hinges.
3. Insert lamp.
4. Before closing lens door make sure frame gasket is properly seated all around fixture.
5. Close door. Tighten 4 screws.
REPLACEMENT LAMPS:
High Pressure Sodium
ANSI Metal Halide
ANSI
Wattage
Catalog #
Code Wattage
Catalog #
Code
70
LHPS70
S62 50
LMH50
M110
100
LHPS100
S54
70
LMH70
M98
150
LHPS175
S55
100 LMH100 M90
150
LMH150PS
M102
150 LMH150 M107
175 LMH175 M57
Fluorescent
Wattage Catalog #
42 LCFL42
CLEANING
Clean reflector and glass refractor with nonabrasive glass
cleaning solution or detergent. Rinse with clean water.
Caution: Be sure fixture temperature is cool enough
to touch.
TROUBLESHOOTING CHECKLIST:
1. Proper lamp is installed. Lamp is not faulty.
2. Fixture is wired properly.
3. Line voltage at the fixture is proper.
4. Fixture is grounded properly.
0˚ Down
0˚ Up
30˚Up
30˚ Down
Thank you for buying RAB lighting fixtures. Our aim is to design the best quality products so you can get the job done right.
We’d like to hear your comments. Call us at 888-RAB-1000, attention Marketing Department or email: [email protected].
LIGHT
FIXTURE
(+) LINE BLACK
(–) COMMON WHITE
GROUND
SUPPL
Y
GROUND
GROUND
GROUND
RAB
LIGHTING Tel: 888 RAB-1000 • Fax: 888 RAB-1232 • www.rabweb.com
