R2TECK DVL-2, User Manual

Page: 14 / 25

12
[8]: MODE light
Light status Description Action
Green light
Turn on
Tracking status NA
Turn off Offline status NA
Green light
flash twice
Auto calibration NA
Red light
turn on
Calibration failed Power again
5.2.3 Below cabin right side port
5.2.3.1
[1]: For Bind the Transmitter and receiver.
Press the button more than 5 seconds, 4 lights (HDMI, LINK, OSD, WORK) are all turn-off, then
stop press the button, 4 lights flash one by one, when the LED light works well that means they are
well binded. This may takes 2 minutes. If the connection has not been resumed after 2 minutes,
repower on both ends, and don’t need to rebind.
[2]: For PW+ button, increase the transmitting power, max 800mW. When display “PW: xxx OK” on
the monitor means successfully set.
[3]: For PW- button, decrease the transmitting power, min 25mW. When display “PW: xxx OK” on the
monitor means successfully set.
[4]: For Power button.
[5]: For monitor: display below data
SP data: (SP:00;
Power data: (PW:0);
Transmitter voltage (VOLTAGE:00.00);
Receiver voltage (VOLTAGE2
：
00.00);
Frequency (FREQ:xxxx).