URPT/MIC & URPR/MIC
ELETTRONICA
35
/ 42
User Manual
Rev. 1.1 - 29/06/12
NOTE:
Repeat
function is used in case you want an receiver in repeater mode
together with a exciter, also if it is of other brands; if you select this mode, the
pin 15 of ACCESSORY connector should be kept to GND to enable the delivery
of output power. If you leave the pin 15 open, the output power is inhibited and
into the main screen of display is written
StdBy
under
Fwd
.
Next, you can review all operating parameters of the equipment through the
management firmware.
Normally, the equipment can run unattended. Any alarm condition is handled
automatically by the safety system or is signalled by the LED indicators on the
panel or by display messages.
NOTE: Standard factory settings are output power set to upper limit (unless
otherwise specified by customer) and
OFF
.
6.4 Management Firmware
The machine is provided with a two-line LCD display where a set of menus is
shown. An overall view of the machine’s menus is given in figure .
One of the following symbols may be present on the left side of the display,
depending on the case:
_ (Cursor) - The cursor indentifies the selected menu where you can have
access.
u
(Full arrow) - The parameter highlighted by the arrow can be modified. This
symbol is present in menu composed of more than two lines as an help in the
scroll menu.
www
(Three empty arrows) - The parameter highlighted by the arrows is in phase
of modification.
w
(Empty Arrow) - The arrow points out the current line, the parameter of which
cannot be modified. This symbol is present in the menus made up of more than
two lines to help scroll the menu.
