13 / 24
User Manual
Rev. 1.0 - 13/03/09
TELINK-SNMP1
Similarly to readings and settings of the measurements, the commands have a
set of OID that are only in writing mode. For each transmitter, the MIB exports a
specifi c set of OID.
The controls can regulate ON/OFF: to activate (ON) the user must send a “2” as
value for the disabled (OFF) the user must send a “1” as value. No other values
are accepted as a command.
Usually the commands are one-shot toggle. In other words, if the transmitter is
turn “ON” (value “2” to set-transmitter-on-10ksd), the next command is a turn
“OFF” (value “2” set-transmitter-off-10ksd ) and not a disable “ON” (value “1” to
set-transmitter-on-10ksd).
Menu 9
5.3.5 Proxy Serial Communication
There are a set of OID that monitoring the serial communication between the
ANTLAN SNMP card and the Main card equipped inside the telemetry unit.
The user can set the system so that all measures are sent to 0 when the serial
communication fails. In this case is also issued a TRAP.
Menù 10
TRAP settings:
Menù 11