SDC100
9 / 42
User Manual
Rev. 3.0 - 09/10/01
5. Quick Start
This chapter gives a concise view of the points that are necessary for the installation
of the device. If any item is not completely clear, for example when you use the
exciter for the first time, we strongly suggest to read throughly the manual.
5.1
Preparation
Unpack the coder and before any other operation check the unit for any shipping
damage and check that all the controls and connectors on the front and rear panels
are in good conditions.
Check the mains voltage selector on the rear panel: the selected value is indicated
by an arrow. If required, extract the selector block levering with a little screwdriver.
Rotate the block until the correct printed value corresponds with the arrow, then
reinsert it.
The voltage selector block also contains the line fuse. The kind of the adapter fuse
is:
A.C. LINE FUSE
1A 5X20
Verify that SDC100 coder is switch off.
Connect the output connector of the mixer or of the last receiver to “Right” and
“Left” input connector. The SDC100 is balanced and can be of “XLR” type or socket
type.
Respect the XLR connectors pins position showed in the chapter 6. SDC100 has
SCA and RDS inputs; the technical caracteristics of these inputs are mentioned in
chapter 7.
NOTE: It’s important don’t connect any audio signals not codified because will be
mixed with MPX signal on the MPX output.
Connect the mains cable to the plug on the rear of the coder.
NOTE: This device shall be correctly connected to ground.
Correct grounding is essential both for safety and to reach the rated performances.
Summary of Contents for SDC100
