10
/ 40
User Manual
Rev. 2.0 - 29/11/22
SCM6/1
ELETTRONICA
5. Quick guide for installation and use
This section provides a step-by-step description of equipment installation and
configuration procedure. Follow these procedures closely upon first power-on
and each time any change is made to general configuration, such as when a new
transmission station is added or the equipment is replaced.
Once the desired configuration has been set up, no more settings are required
for normal operation; at each power-up (even after an accidental shutdown), the
equipment defaults to the parameters set during the initial configuration procedure.
The topics covered in this section are discussed at greater length in the next
sections, with detailed descriptions of all hardware and firmware features and
capabilities. Please see the relevant sections for additional details.
IMPORTANT:
When configuring and testing the transmitter in which the equipment
is integrated, be sure to have the Final Test Table supplied with the equipment ready
at hand throughout the whole procedure; the Final Test Table lists all operating
parameters as set and tested at the factory.
5.1 Using the encoder
The interaction between the user and the exciter’s control software is performed
using the encoder (fig. 5.1).
Turn the encoder counterclockwise
to move the cursor downwards, to
decrease the value of a parameter
or to choose an element from a list
of possibilities.
Turn the encoder clockwise to
move the cursor upwards, to incre
-
ase the value of a parameter or to
choose an element from a list of
possibilities.
Push the button once to enter in the desired
menu, to enter in modification mode or to
confirm a choice.
Figure 5.1
The operations that can be performed on the encoder are:
• rotation
: moves the cursor shown on the display; if you turn the encoder to
the left (counterclockwise), the cursor moves downwards, if you turn it right the
cursor moves upwards; it also permits to increase or diminish the parameters
(turning the encoder left diminishes the parameter, turning it right increases it)
or to select an item form a list of options.
• pression
: push the button once when the cursor is on the name of a menu to
enter in that menu, push it when the corsor is on the name of a parameter to
enter in modification mod (the cursor starts blinking); after the modification of
a parameter, push the button to save the new value.
Summary of Contents for SCM6/1
Page 1: ...SCM6 1 SCM6 1 USER MANUAL VOLUME1 Manufactured by R V R ELETTRONICA Italy ...
Page 4: ...ii User Manual Rev 2 0 28 10 22 SCM6 1 ELETTRONICA ...
Page 6: ...iv User Manual Rev 2 0 28 10 22 SCM6 1 ELETTRONICA This page was intentionally left blank ...
Page 46: ...40 40 User Manual Rev 2 0 29 11 22 SCM6 1 ELETTRONICA This page was intentionally left blank ...
