PJ5000U-K
41
/ 48
User Manual
Rev. 3.0 - 21/03/18
• Replace the RF module in its housing and resolder the points
B
points.
• Place an amperometer in series to 50VDC (see points
D
). Verify, with the
equipment switched on but without power input, that there are 1A otherwise
intervene on the trimmer
E
until to the reading of the indicated value. However,
if the amperometer does not provide any indication, it is very probabely that
the fuse is broken.
Proceed with its replacement by following the next chapter.
D
E
• At this point, screw the screws into the position
C
.
• Reconnect the connector in its housing
A
.
• Put the cover back on and tighten all the screws necessary to close it.
9.4.2 How to replace the fuses
• Unscrew all screws
A
on the front panel of
PJ5000U-K
.
