18
/ 34
User Manual
Rev. 1.0 - 05/04/13
PJ3500M-C & PJ5000U-K
As a rule, the machine does not need to be manned to work. If any alarm conditions
occur, they will be managed automatically by the protection system or notified to
the user by means of LEDs on the panel and messages on the display.
5.3 Software
This chapter describes the ways in which the microprocessor controls the amplifier
and how the user may interact with the software.
The figure in the follow shows the overall software user interface diagram.
Figure:
Flow diagram of the software
Switch On
ESC
ENTER
Operation Menu
Power Menu
P.A. Menu
Set Up Menu
ENTER
ENTER
ENTER
ENTER
Selection Menu
ENTER
Miscellaneous Menu
Alarm Menu
ENTER
Version Menu
ESC
Note:
the user may issue commands to the equipment only when in LOCAL mode
by means of the selector. Otherwise the user may only read the parameters and
not change them.
When turned on, the LCD shows the introductory screenful with the equipment’s
software and hardware versions.
A few seconds later the main screenful is displayed indicating the forward and
reflected power values:
