HC5
27 / 34
User Manual
Rev. 1.0L - 11/02/02
9. Theory of Operation
The figure shows the block diagrams of HC5. The blocks are described in the
following chapter:
9.1
Power supply
This equipment has only a transformer with different outputs. The used outputs
are: 0-18V for the supply of the remote card and 0-11,5V for the CPU section. The
rectifiers and the stabilizers are in the two cited cards.
9.2
Power Splitter
The Power Splitter circuit mounted on the rear part of the equipment where are
find the input connector from the exciter and the RF outputs to the amplifiers.
The circuit is realized with strip plus coaxial cables and five specific circuits can
adjust (equalize) phases on the five outputs that are used to drive the amplifiers.
Five resistive termination placed near to the output serves to absorb any unbalanced
powers in case of faulty or performance differences of some amplifier to prevent
excessive power driving on the well functioning (well loaded) outputs.
9.3
Power Combiner
The function of the coupler section is to add the RF power portions provided by
the amplifiers and to pass it through the antenna output.
Summary of Contents for HC5
