4 / 14
User Manual
Rev. 1.0 - 16/11/07
GPSRXNV-01
5. Quick guide for installation and use
This section provides a step-by-step description of equipment installation and
configuration procedure. Follow these procedures closely upon first power-on
and each time any change is made to general configuration, such as when a new
transmission station is added or the equipment is replaced.
Once the desired configuration has been set up, no more settings are required
for normal operation; at each power-up (even after an accidental shutdown),
the equipment defaults to the parameters set during the initial configuration
procedure.
The topics covered in this section are discussed at greater length in the next
sections, with detailed descriptions of all hardware and firmware features and
capabilities. Please see the relevant sections for additional details. The topics
covered in this section are discussed at greater length in the next sections, with
detailed descriptions of all hardware and firmware features and capabilities. Please
see the relevant sections for additional details.
5.1 Preparation
5.1.1 Preliminary checks
Unpack the GPS receiver and immediately inspect it for transport damage. Ensure
that all connectors are in perfect condition.
Provide for the following (applicable to operating tests and putting into service):
√
Single-phase 230 or 115 (-15% / +10%) Vac mains power supply, with adequate
earth connection.
√
Connection cable kit including:
• Mains power cable.
• Cable to connect the 1 PPS TTL signal (
sold separately
).
• Cable to connect the 10 MHz signal (
sold separately
).
• GPS receiver antenna (
sold separately
).
