8 / 14
User Manual
Rev. 1.0 - 16/11/07
GPSRXNV-01
6 External Description
This section describes the components found on the front and rear panel of
GPSRXNV-01
.
6.1 Frontal Panel
Figure 6.1
[1] AC-ON
Green LED, when lit on indicates the presence of mains power supply.
[2] DC-ON
Green LED, when lit on indicates the presence of continuous power
supply; in case this LED is ON while that AC-ON is off, it indicates that
the receiver is powered by battery.
[3] GPS-LOCK
Green LED, when lit on indicates the correct reception of satellite
signals.
[4] EBO-OK
Green LED, when lit on indicates the correct synchronization.
[5] RS232
DB9-F connector for direct serial communication.
6.2 Rear Panel
Figure 6.2
[1] MAINS
VDE connector for mains power supply, fuse protection and voltage
changer block 100-110-230-250V 50-60Hz.
[2] BATTERY
Switch to enable or disable the power supply of buffer battery.
[3] ALARMS
DB9-M connector for the alarm output status of the equipment through
the contacts available.
[4] 10MHz OUT - 1
BNC connector for the signal output at 10MHz for the synchronism of
the carrier.
[5] 10MHz OUT - 2
BNC connector for the auxiliary signal output at 10MHz for the
synchronism of the carrier, only in case of presence of proper option.
[6] 10MHz OUT - 3
BNC connector for the auxiliary signal output at 10MHz for the
synchronism of the carrier, only in case of presence of proper option.
[7] 10MHz OUT - 4
BNC connector for the auxiliary signal output at 10MHz for the
synchronism of the carrier, only in case of presence of proper option.
[8] 1pps OUT TTL - 1
BNC connector for the signal output of 1 PPS TTL for the synchronism
of the carrier.
[9] 1pps OUT TTL - 2
BNC connector for the signal output of 1 PPS TTL for the synchronism
of the carrier, only in case of presence of proper option..
[10] 1pps OUT TTL - 3
BNC connector for the signal output of 1 PPS TTL for the synchronism
of the carrier, only in case of presence of proper option.
[11] GSM ANT
Type-N connector for antenna receiver input.
