Welding in TIG mode - with Remote foot pedal
1
Connect the TIG Torch to machine, connect earth lead to machine & work piece.
2
Connect remote foot pedal to machine
3
Set the TIG/MMA/MIG switch to TIG
4
Select 2 way torch operation
5
Connect Argon gas and set flow to approx 8-12 LPM
6
Set Gas post flow to 6 - 10 Seconds, higher amperage requires more post flow.
7
Press the foot pedal to start welding.
Note: When welding with the remote foot pedal
Upon pressing of foot pedal welding arc will start, if you find it hard to start an arc push the pedal down a bit further
to aid starting.
The benefits of welding with a remote foot pedal is that of greater control of the amount of heat going into the work
- Press the pedal fully to start welding; upon weld pool formation you can slightly release the pedal to decrease the
amperage to sustain a perfect weld pool and increase it again as required to sustain the weld characteristics.
Welding in STICK MMA (SMAW) Mode - no remote foot pedal
1
Fit MMA electrode holder to machine
2
Fit earth lead to machine and to work piece
3
Select MMA on MMA/TIG/MIG switch
4
Place electrode in holder
5
Select desired welding current
6
Select desired Arc Force
7
Strike arc and weld
Welding in STICK MMA (SMAW) Mode - with remote foot pedal
1
Fit MMA electrode holder to machine
2
Fit earth lead to machine and to work piece
3
Select MMA on MMA/TIG/MIG switch
4
Place electrode in holder
5
Select desired Arc Force
6
Connect remote foot pedal to machine
7
Select desired welding current
8
Strike arc and weld
18
