R-Tech PLASMA 80HF, Operation Instructions Manual

Page: 16 / 19

16
air supply. Check for adequate ventilation around machine
6.
Erratic cut – Torch spitting when cutting
Check torch consumables and replace if necessary as per instructions earlier in this
manual
Check if correct amperage for thickness of metal, if to slow travel speed or to much
cutting power, increase speed of cut or reduce cutting amperage. (When machine
senses no metal left to cut it will switch of main cutting power and switch on HF pilot
arc, this is the HF pilot arc restart)
Water contamination in torch head, Check for water in water trap at rear of machine, if
water is present, drain air compressor, clean water out of air lines, empty water trap by
pressing water release button on bottom of air regulator water trap. Fit new
consumables as per instructions earlier in this manual
Plasma Torch Consumables parts list
R-Tech Torch Spares
Plasma 80HF Part No.
Electrode P40-EL
Cutting Tip 1.0mm 40 Amp P40-CT1
Ceramic Cup P40-CC
Spring, Stand off P40-SS
Torch Head –Hand Held P40-THH
Torch Complete Hand Held 6M P40-6MHHT
Plasma 60,80,100 HF
Electrode P60100-EL
Cutting tip 0.8mm 30 Amp P60100-CT08
Cutting tip 1.1mm 60 Amp P60100-CT11
Cutting tip 1.3mm 80 Amp P60100-CT13
Cutting tig 1.5mm 100 Amp P60100-CT15
Shroud P60100-SH
Torch Head hand held P60100-THH
Torch Head Machine P60100-THM
Torch Complete 6m Hand Held P60100-6MHHT
Torch Complete 6m Machine type P60100-6MMTT