1. Turning adjustment knob
"A"
clock-wise
(tightening) will lower tips & raise center.
(SEE PICTURE BELOW.)
2. This squeegee is adjusted too far back and will not
pick up on the corners.
*
note tips off the floor*
.
(SEE BELOW)
3. This squeegee is adjusted too far forward and will not
pick up in the center. *note center spaced off the floor*.
(SEE BELOW)
4. This squeegee is adjusted just right with good
deflection across the entire rear blade.
(SEE BELOW)
ADJUSTING SQUEEGEE
REPLACING OR ROTATE
SQUEEGEE BLADES
FOR SAFETY:
Before leaving or servicing machine
stop on level surface, turn off machine and
remove key.
1. Remove the squeegee assembly from the
machine. Remove blade retainer strap and
remove squeegee blade.
2. Rotate the squeegee to new edge position or
replace as required.
3. Install blade on the locating pins of squeegee
assembly.
4. Install squeegee retainer strap.
5. Fasten and lock knobs.
REMOVING SQUEEGEE
1. With the squeegee in the up position,
turn machine power off.
2. Disconnect vacuum hose
"A"
from squeegee
and loosen both knobs
"B"
. (SEE BELOW
)
3. Pull squeegee assembly rearward from the
lifting carrier.
4. Inspect or repair as needed and reinstall.
PAGE 10
A
B
B
2.
2.
A
3.
