R.E.
Williams
Contractor
Inc.
www.rewci.com
Dimensions
CL4210 LATCH FUNCTION
Outside handle turns freely without operating the latchbolt.
When the code is entered the Blue light flashes, and the
handle will retract the latchbolt.
The latch automatically locks the door when closed. The
key will open the door without the code.
Installation
Take time to be precise and finish the job quicker
Installation holes must be drilled in exactly the correct
positions and precisely at right angles to the door surface.
Lock components must be vertically and horizontally
accurate in relation to each other and to the door.
WEDGE THE DOOR FIRMLY TO PREVENT MOVEMENT
WHILST DRILLING AND CHISELLING
1. Lightly mark a height line on the door edge and both
faces of the door and on the door jamb, to indicate the top
of the lock when fitted. Crease the template along one of
the dotted lines (2 3/8" or 2 3/4" (inches) latch) and tape it
to the door with the top in line with the height line. Mark the
holes to be drilled.
Mark the centre of the door edge on the Centre Line of
Latch. Apply the template to the other side of the door
precisely against the height line and the centre line of latch
mark. Mark the holes to be drilled again.
2. Keeping the drill level and straight, drill a 1" (inches) hole
on the centre of the door edge to accept the latch.
3. Keeping the drill level and straight, drill the holes to the
door face. Drill from both sides of the door to increase
accuracy and to avoid damage to the other side when a drill
goes right through.
4. Put the latch into the hold and, holding it square to the
door edge, draw around the faceplate. Starting with the top
and bottom cuts, chisel a rebate to allow the latch face to
flush with the door edge. (See diagram A).
