QVI Cobra DRS-2000, User Manual

Page: 39 / 100

12. If you purchased the Factory-supplied Computer option, unpack and set up
the computer and components at this time.
13. Connect a parallel cable from the
PARALLEL PORT
on the Cobra back
panel (see Figure 2-18) to the parallel port on the associated computer.
14. Plug the female end of the supplied Cobra power cord into the power cord
receptacle on the Cobra back panel (see Figure 2-18) and connect the male
end into a properly configured outlet.
15. If necessary, plug the Motor cable into the
AUX AXIS
port on the Cobra
back panel (see Figure 2-18).
16. If you did not purchase the Factory-supplied Computer option, install the
Scan-X software onto the associated computer (described later in this
section). It is pre-installed on computers purchased from the factory.
This completes the Cobra 3D installation procedure.
2-18 Installation and Setup
Figure 2-18. Cobra 3D Back Panel