QVI Cobra DRS-2000, User Manual

Page: 29 / 100

5. Carefully swing the camera assembly to the right (or left) to reveal the
lower screw hole in the camera mounting plate. Then insert one of the three
partially-threaded screws into the hole and push it through the camera
mounting plate and sensor.
The camera is still attached to the mounting plate via the LED power wires (red
and black). These two wires are fairly delicate. Therefore, keep the camera close
to the mounting plate to avoid damaging either of these two wire
6. With your left (or right) hand, carefully pick up the camera mounting plate
and laser sensor, and then position and hold them on the sensor mounting
pad. Use the two positioning pins on the sensor mounting pad to align the
sensor and camera mounting plate over the mounting holes in the mounting
pad. When positioning the components, make sure that the camera
mounting plate remains aligned on the sensor.
7. With your free hand, use a 3 mm hex key (Allen) wrench to tighten the
partially-threaded screw you inserted into the lower mounting hole (Step 5)
and secure the camera mounting plate and sensor to the sensor mounting
pad.
Use Figure 2-6 for reference.
2-8 Installation and Setup
Figure 2-6. Attaching the Camera Mounting Plate and Sensor