1 Tap through
work top
Push the tap through the hole in the
work top.
2 Securing tap
Position the brass fixing plate around
the hoses. Screw the fixing nut onto
the tap thread. Adjust the position of
the tap to ensure that the Quooker
logo is facing the user. When the
handle is in the cold position, it will
be parallel to the edge of the work
top. Tighten the fixing nut with a pipe
wrench, socket wrench or spanner.
3 Fitting to thin
work top
When fitting to a thin work top, use
the white tap support before fitting
the brass fixing plate around the
hoses.
4 Connecting
hoses
Insert the inlet hose screens and
connect the hot and cold water inlet
hoses to the mains.
1
2
Fitting Fusion tap
• Note: The total length of the hose between the single tap and tank is only
70 cm. The tank must therefore be fitted close to the tap. Extension hoses
for the boiling water hose are available in different lengths but are not
normally required.
• Note: The small fibre washers supplied with the tap rings are not required
yet at this point. One will be used for connecting the tap and tank hose (see
section E), the second one is a spare.
B
2
3
4
Installatieinstr VAQ E UK 30.225.03.V15 11-12-18 09:32 Pagina 13
