Quonset Microwave QM1004A-2-18, User Manual

Page: 42 / 103

QM1004A-2-18 Combined RF Upconverter/Downconverter User Manual
1. Command Quick Reference Guide
1.1 Common (*) Commands
Table 4.1: Common (*) Commands Summary
Command Page Description
*CLS 73 Clears the data structures. The SCPI registers are
cleared.
*ESE < NRf > 74 Sets the Standard Event Status Enable Register.
*ESE? 74 Returns the Standard Event Status Enable Register.
*ESR? 75 Returns the contents of the Standard Event Status
Register and then clears it.
*IDN? 76 Returns the identification of the device connected to
the computer (Host).
*OPC 77 Causes the Combined RF Upconverter/Downcon-
verter to set the operation complete bit in the Stan-
dard Event Status Register when all pending opera-
tions have completed.
*OPC? 77 Returns the operation complete bit in the Standard
Event Status Register when all pending operations
have completed.
*RCL
<
NRf
>
78 Recalls the settings of the Combined RF Upconvert-
er/Downconverter from the specified register (memory
location).
*RST 79 Returns the Combined RF Upconverter/Downcon-
verter to its initial power up state.
*SAV < NRf > 80 Saves the settings of the Combined RF Upconverter/-
Downconverter to the specified register (memory loca-
tion).
*SDS < NRf > 81 Saves the default settings of the Combined RF Upcon-
verter/Downconverter to the specified register (mem-
ory location).
*SRE < NRf > 82 Sets the Service Request Enable register bits.
*SRE? 82 Returns the Service Request Enable register bits.
*STB? 83 Returns the Combined RF Upconverter/Downcon-
verter status byte.
*TST? 84 Performs a self-test and returns the result.
*WAI 85 Causes the Combined RF Upconverter/Downcon-
verter to wait until either all pending commands are
complete, the Device Clear command is received, or
the power is cycled before executing any subsequent
commands or queries.
Quonset Microwave Revision 1.4.3 30