Quonset Microwave QM1003-0.5-18-2, User Manual

Page: 39 / 100

QM1003-0.5-18-2 Dual Channel RF Downconverter User Manual
1. Command Quick Reference Guide
1.1 Common (*) Commands
Table 4.1: Common (*) Commands Summary
Command Page Description
*CLS 72 Clears the data structures. The SCPI registers are
cleared.
*ESE < NRf > 73 Sets the Standard Event Status Enable Register.
*ESE? 73 Returns the Standard Event Status Enable Register.
*ESR? 74 Returns the contents of the Standard Event Status
Register and then clears it.
*IDN? 75 Returns the identification of the device connected to
the computer (Host).
*OPC 76 Causes the Dual Channel RF Downconverter to set
the operation complete bit in the Standard Event Sta-
tus Register when all pending operations have com-
pleted.
*OPC? 76 Returns the operation complete bit in the Standard
Event Status Register when all pending operations
have completed.
*RCL
<
NRf
>
77 Recalls the settings of the Dual Channel RF Downcon-
verter from the specified register (memory location).
*RST 78 Returns the Dual Channel RF Downconverter to its ini-
tial power up state.
*SAV < NRf > 79 Saves the settings of the Dual Channel RF Downcon-
verter to the specified register (memory location).
*SDS < NRf > 80 Saves the default settings of the Dual Channel RF
Downconverter to the specified register (memory lo-
cation).
*SRE < NRf > 81 Sets the Service Request Enable register bits.
*SRE? 81 Returns the Service Request Enable register bits.
*STB? 82 Returns the Dual Channel RF Downconverter status
byte.
*TST? 83 Performs a self-test and returns the result.
*WAI 84 Causes the Dual Channel RF Downconverter to wait
until either all pending commands are complete, the
Device Clear command is received, or the power is
cycled before executing any subsequent commands or
queries.
1.2 FREQuency Subsystem
Quonset Microwave Revision 1.0.0 28