Page 4
For technical questions, please call 1-888-866-5797.
Item 58950
Functions
Adjusting Ring
Handle
Main Torque
Value Scale
Scale Ring
Hex Drive
Operating Instructions
CAUTION!
Wear ANSI-approved
safety goggles during use.
Note:
The Torque Screwdriver is marked
with Inch Pounds. The following instructions
illustrate use in Inch Pounds.
1. BEFORE EVERY USE, exercise Torque
Screwdriver. Pull down Adjusting Ring, then
perform the following exercise three times:
a. Turn Handle to the right until maximum
torque setting is reached.
b. Turn Handle to the left until minimum
torque setting is reached.
CAUTION!
To prevent damage to the Torque
Screwdriver, do not use for loosening fasteners.
2. Clean the fastener’s threads. Dirty threads
may result in a misleading torque reading.
3. Select bit that properly fits the fastener.
Press bit firmly in Hex Drive.
Note:
Thread fastener with another tool
until it is snug, then finish the operation
with the Torque Screwdriver.
4. Pull down Adjusting Ring and hold
in place while adjusting torque.
5.
To set torque value to 24:
a. Turn Handle until the “0” on
Scale Ring lines up with the “20” on
the Main Torque Value Scale.
b. Continue to turn Handle until the “4” on
Scale Ring lines up with center line on
Main Torque Scale. The torque value
is set to 24 in-lb. (20 + 4 = 24).
6. Release Adjusting Ring to
lock Handle in place.
7. Place Torque Screwdriver onto
fastener at a 90 degree angle.
8. Rotate clockwise smoothly until a click is
heard.
STOP ROTATING! The proper
torque has been achieved. Further
rotating may damage fastener.
9. Release pressure to allow the Handle
to reset for the next operation.
10. AFTER EVERY USE, pull down
Adjusting Ring, set to the lowest torque
setting, then release Adjusting Ring.
11. Store Torque Screwdriver inside its
case, indoors, in a clean, dry location
that is out of reach of children.
