20
V3 CYCLE ANALYST BASICS
The below directions are intended for basic use only. For further directions on the V3 Cycle Analyst refer to the
link provided in the appendixes or call our customer service department at 970-328-6629
Main Navigation:
1.
While in the main screen, hold the left button until you see “Enter Setup”, then release the button and it will
say “Setup Spdometer” indicating the Speedometer Setup.
2.
Tap the left or right buttons to move through the menus
3.
When you get to the menu you want, hold the right button until it say “OK”, and then release, now you are in
that menu.
4.
Tap the right button to move through the entries until you get to the one you want to change.
5.
Hold the right button until the number is blinking. You will be able to change it one digit at a time using the
left button to lower the number and the right to raise it.
6.
Hold the right button after you get the correct number, and it will move right to the next digit and repeat the
process with each digit until it stops blinking.
7.
Tap the right button to continue through the entries until you get back to the original menu screen where you
can navigate to the next menu.
8.
When finished, tap the right button until it says leaving setup. From here you can drive again.
9.
If you turn off the Cycle Analyst during this process, turn it back on and you will return to the originalscreen
with all the changes saved.
To change the modes from Economy, Off Road, and Unlimited:
1.
Press and hold the left button and then tap the right to move through them.
Low
Medium
High
2.
Release the buttons when you are finished.
