QuickWorldWide Little Sweetie 10 Pro, Assembly & Maintenance Manual

Page: 63 / 69

FRE-FLIGHT CHECKS
•
The rotor flybar and shaft must be straight.
•
The flybar and control paddles must tilt in the proper direction and operates smoothly
throughout the whole range.
•
Check the swashplate to make sure it move smoothly and clean.
•
When control input are given to tilt the swashplate, make sure no control arms or
pushrods are binding.
•
Check the two control paddles for level, parallel, and proper direction.
•
Make sure the batteries are fully charged.
•
Make sure the radio and receiver are on and all controls operate properly before
flight.
•
There should be no interference of radio signal in your flying zone. Range check the
radio.
Always grab onto the helicopter main rotor head when turning on the helicopter.
WARNINGS
•
Do not operate helicopters in rainy, windy, or snowy condition.
•
Operate helicopter in a safe zone away from crowds, traffic, or distractions.
•
Use the proper batteries to prevent damage to the motor and equipment.
•
Make sure all the batteries are fully and properly charged.
•
Make sure all the controls operate properly before flight.
•
The main and tail rotors blades operate at very high speed (rpm); therefore,
make sure nothing can come into contact with them while they are spinning.
•
Perform a range check on the radio before flying.
•
Make sure the transmitter and receiver are turned on before plugging in the main
power battery/batteries.
•
Keep a safe distance when operating a helicopter.
•
Do not fly for a long period of time. Take some rests during flights.
•
Motors are often very hot after operation. So be careful when handling or
touching them immediately after flying.
Page 63 of 69