10
Control panel
A - pressure [bar]
B - flow [l/min]
C - power [kW]
D - temperature [0
°
C]
E - digital display
F - indicator of medium temperature setting
(for DHW cylinder)
G - indicator of room thermostat and heating
activity (for central heating)
H - indicator of pump and flow activity
I,J - inactive indicators
K - inlet temp. indicator
L - outlet temp. indicator
M - indicator of boiler activity (for central
heating)
N - indicator of boiler activity (for DHW
cylinder)
O - control buttons
The control panel consists of two working areas: the signalling area (elements: A-N)
and control area (O). The user can select the following working modes:
-
stand-by, winter (CH heating or CH + DHW heating), summer (DHW heating) for
EKCO.LN2 and EKCO.L2,
-
stand-by, winter (CH heating) for EKCO.LN2...p and EKCO.L2...p.
To switch between working modes press
.
Stand-by mode
To set the stand-by mode press
. and hold for 3 seconds. Important: Do not cut
power supply off between heating season. When the control panel is switched to
„Stand-by” mode the control panel is off (the F icons flickers only). In this mode the
boiler is off but the pump is activated every day for 15 minutes (what protects the
boiler and the whole central heating installation from being blocked and silted up).
The pump will run every day at the same time, it will be the time of the day when you
switch it to the „Stand-by” mode e.g., if you set the pump on a „Stand-by” mode at 6
p.m. the timer will activate the pump everyday for 15 minutes starting at around 6 p.m.
To check out the installation pressure press
or
To set the winter mode press
, (when you set from „Stand-by” to „Winter mode”).
-
type of flow sensor – (1) HC DN 15 sensor, (2) KOSPEL sensor,
-
work-time counter of boiler (read-only time). Counter display shows figures (with-
out leading zeros) starting from the most important with 1/2 second intervals, the
display will turn off (for 2 seconds) when the least important figure is shown,
Press and hold the
button to exit and save the settings.
