ENGLISH
25
Attitude/Attitude Hybrid Rev.1.0
Fitting and removing the sMMI
Fitting:
•
Place the sMMI [4] in the correct position, (the
neodrives logo faces the rider) and skewed at an
angle of about 30 degrees to the dock [5] (Fig.3.1).
•
Turn the sMMI [4] on the dock [5] using slight pressure
by 30 degrees clockwise so that both components are
in alignment, (Fig.3.2).
•
The electrical connections to the controller, motor and
battery pack are thereby automatically established.
Removing:
•
Turn the sMMI [4] on its dock [5] by about 30 degrees
anticlockwise.
•
The electrical connections are thereby disengaged
and the sMMI [4] can be removed.
•
Before removing, the sMMI needs to be switched off,
(see "Functions").
CAUTION!
•
To protect your add-on bike from unwanted use by a
third party or against theft, the sMMI should always be
removed from the handlebar when not in use.
•
Removing the sMMI, though, does not replace
securing your add-on bike against theft by other
suitable means (using a bicycle lock, a safety chain or
similar device).
Functions of the sMMI
Switching On:
To switch on the sMMI, tap the menu button [3] on the
controller. After a few seconds a welcome screen
appears, followed by the start menu, which is shown to
the side.
If functions are already activated or the battery is not
fully charged, the display of your sMMI may differ from
the illustration in some parts.
Switching off:
To switch off your add-on bike you need to press down
button [2] on the controller for about 2 seconds when the
start menu is displayed. This takes you to the sub menu
depicted to the side, in which display you can jump up or
down using buttons [1] and [3] of the controller.
The selected field in each case is displayed within a
U-shaped border.
Select the field “Turn off” and tap button [2]. Your add-on
bike is now switched off.
Automatic switch-off:
If your add-on bike is not used for 10 minutes, the
system is automatically switched off.
Pressing the menu button again switches the system on
once more.
CAUTION!
Do not switch your Attitude off by removing the sMMI,
the electronics could be damaged by this.
Fig.3.2
Fig.3.3
Fig.3.5
0
km/h
km
115
6
7
11
12
8
9
10
Fig.3.4
3
2
1
Summary of Contents for Attitude
