20
TCD 2044
EN
INSTALLATION AND USE MANUAL - REV 002A
Use the switch on the supply line to switch the control on and off. Once the power supply has been connected, the con-
trol will test the LEDs. For the LED test, all the LEDs will come on simultaneously for 2 seconds. If no errors or problems
are detected, the control will then go to the disabled state (see Disabling the control).
ATTENTION:
practice controlling the thrusters in open water, to avoid damaging the boat with accidentally wrong
manoeuvres.
ATTENTION:
make sure no swimmers or floating objects are in the vicinity before switching on the thruster.
ENABLING LED
ENABLING BUTTON
ENABLING LED
BOW JOYSTICK
STERN JOYSTICK
BOW
RIGHT DIRECTION LED
BOW
LEFT DIRECTION LED
STERN
RIGHT DIRECTION LED
STERN
LEFT DIRECTION LED
Enabling button
The button enables or disables the control.
Bow Joystick
When the bow joystick is moved to the right at the end of its stroke, it moves the bow of the boat to the right.
When the bow joystick is moved to the left at the end of its stroke, it moves the bow of the boat to the left.
Stern Joystick
When the stern joystick is moved to the right at the end of its stroke, it moves the stern of the boat to the right.
When the stern joystick is moved to the left at the end of its stroke, it moves the stern of the boat to the left.
Enabling LEDs
The enabling LEDs indicate the enabled/disabled state of the control.
Direction LEDs
The direction LEDs indicate the movement of the boat to the right or left.
All LEDs are also used to signal any errors or problems.
3.1 - Control panel
3.0 - OPERATION
The user interface is composed of:
• 1 enabling button
• 2 joystick
• 2 enabling LEDs
• 4 direction LEDs
3.2 - Switching on the control
