CHARACTERISTICS / INSTALLATION / OPERATION
EN
8
QUICK SPA
QCC-SPT DMX - REV001A
INTENDED USE
• The QCC-SPT DMX is intended to be used in nautical applications to control the colour and adjust the brightness of
RGBW LED light sources in constant current.
• For fire-prevention reasons, install the QCC-SPT DMX in a ventilated, controlled-temperature environment, protected
from dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Any other use should be considered improper and unpredictable.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT. IN CASE OF
DOUBT, CONTACT YOUR DEALER OR QUICK
®
CUSTOMER SERVICE.
THE PACKAGE CONAINS: QCC-SPT DMX - conditions of warranty - the manual of installation and use..
F
PRODUCT DESCRIPTION
QCC-SPT DMX is a device for switching the DMX512
signal and it is needed if you want to have more than
one DMX512 control devices (for instance, the QCC-
LCS TP).
TECHNICAL ELEMENTS AND DEFINITIONS
• DMX512 signal: in this specific manual, this is the electrical control signal generated by a control device.
• control device: in this specific manual, this is a user interface that generates the control signal (indicated in the
connection diagram with DMX 512 device).
INSTALLATION AND MAINTENANCE
• The device must be placed in a suitably protected distribution board so that it can operate under the environmental
conditions indicated in the general specifications for use, and is not within reach of personnel who are not qualified.
• Always disconnect the supply voltage during installation and maintenance operations.
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the product.
OPERATION
QCC-SPT DMX can receive up to 4 DMX512 input signals from QCC-LCS TP control devices (or any other unit that uses the
DMX512 protocol). QCC-SPT DMX checks and switches the different DMX512 signals sending out only one DMX512 signal.
NOTE: if there are several QCC-LCS TP control points and you want to enable one of the colour change options, you have
to disable it always from the specific control device that enabled it.
Summary of Contents for QCC-SPT DMX
Page 2: ......
