17
EN
MSC MOTOR SPEED CHANGER REV000A
INSTALLATION - OPERATION - NOTIFICATION
5 cm
5 cm
5 cm
5 cm
LED STATUS
DESCRIPTION
Off
Device not powered
Steady LED on (green)
Drive switched on and enabled
Short flashing (green)
Drive switched on with analog command connected and disabled
Long flashing (green)
Drive switched on with CAN command connected and disabled
Quick flashing (orange)
Drive switched on, no command connected
OPERATION
The MSC device can be controlled directly by analog PAJ 1T MSC command, up to a maximum of two stations connected
to connectors
or via CAN bus interface
.
For use with analog command, refer to the installation and operating manual of the PAJ 1T MSC command.
NOTIFICATIONS
The indications provided by the status
LED are listed in the following tables.
WITHOUT PROBLEMS
INSTALLATION SITE
Install the MCS device as close as possible to the motor in a dry and airy
spot, to allow the correct operation of the device at full power.
The MCS device can be installed on a horizontal surface or vertical wall
paying attention that the output connector faces downwards.
Vertical installation is recommended since the natural convection of the
heat will favour the cooling of the device.
The MCS device must be fixed to the support surface with screws strong
enough to support its weight, paying attention that they do not weaken or
cause cracks to the boat structure.
The perimeter of the MCS device (excluding the support base) must be kept
at a distance from walls or objects by a minimum of 5 cm.