11
EN
INSTALLATION AND USE MANUAL
QUICK MC² X19
REV002A
2 - Supplied parts
MC
2
Quick
gyro stabilizer is equipped with all the parts needed for its installation.
2.0 - Package contains the following parts
1
Pre-wired
MC
2
X19 Gyro stabilizer
1 Power cable
(6 m long)
1 AC DYNAMIC CONTROL MC
2
Driver
to control and operate the gyro
1 J1
Extention CAN BUS
(6 m long)
1 J2
Extention CAN BUS
(6 m long)
1 J5
Extention CAN BUS
(6 m long)
4 Eye bolts
for
MC
2
X19
stabilizer lifting
1 Template t
o install the
MC
2
X19
stabilizer
Screws
with resistance category higher than
10.9 (Grade 8)
. Tightening torque
136 Nm (1203.7 lbf/inch) - M12
1 Template
to install the
AC DYNAMIC CONTROL MC
2
driver
INSTALLATION AND USE MANUAL
The warranty
2.1 - Needed accessory and material included in its packaging
Not supplied with the stabilizer
• RC Remote Control MC
2
touch 5", IP66 - It allows you to turn the stabilizer on and off
and monitor its status ( also in multi-station).
Supplied with:
- template for mounting the Remote Control
- J3 RC Extention CAN BUS
for the CAN BUS connection to the
RC Remote Control MC
2
- CAN 5P T F/F/F connector
- CAN Terminator.
2.2 - Required components, not supplied with the stabilizer
• Differential circuit breaker for connecting the AC DYNAMIC CONTROL driver.
2.3 - Tools needed for installation
• Lifting straps
• Torque wrench
• Drill & drill bit 11 mm (7/16")
• Fork key 17 mm (21/32")
• Hexagonal key 8 mm (5/16")
