3.2 Initial Status
Switch on the device and after a few seconds’ initialization, it presents start-up pictures as
below:
B-HDMI-ASI-IP-4CH
HD Encoder
: Module number and name
P1
: Program 1;
P2
: Program 2;
P3
: Program 3;
P4
: Program 4
X.XX Mbps
: indicate the current encoding bit rate of the corresponding channel.
3.3 General Settings for Main Menu
Press LOCK key on the front panel to enter the main menu. The LCD will display the
following pages where user can configure the parameters for the device.
User can press UP/DOWN buttons to specify one item and then press ENTER to enter
its submenus. Press MENU to step back to upper level menu.
1)
Status
Alarm
The alarm indicator will turn on if there is no A/V signals inputting or outputting bit
rate overflows. User then can enter this menu to check the error type.
Uptime
Start up…
Start OK…
B-HDMI-ASI-IP-4CH
HD Encoder
P1:X.XXMbps P
2: X.XXMbps
3 TS Config
4 Network
5 System
1 Status
2 Input Sets
1.1 Alarm
1.2 Uptime
HDMI MEPG-2 H.264 Encoder
User Manual
B-HDMI-ASI-IP-4CH
www.questtel.com
