Page: 6
A5505
Screen House Pro Vehicle Connector Full Instructions
Fitting - Adjusting the tunnel
How to fit the vehicle connector.
Adjusting the tunnel
• Once pegged you can adjust the tunnel to get the best fit possible. These steps are optional, but it
is always best practice to get the tunnel as tight as possible.
• Start with the elastic cord located at the bottom rear of both sides of the tunnel. Pull the elastic
cord as tight as possible and then push the 'ruffled' fabric all the way to the top of the tunnel. The
ruffled fabric should push all the way up so it is above the door on the side of the tunnel.
• Next you can use the two straps shown in image 1 below. These straps can be adjusted to help
gather any excess fabric up, or simply to hold the ruffled fabric you pushed up from using the
elastic cord. Once complete it should look like image 2 below.
•
Adjusting the tunnel additional option
• We have found that some people also like to peg the connection tunnel on the opposite side of
their vehicle to pull it against the vehicle even more (usually when the tunnel is attached to a roll
out canopy as shown in images 2 and 3 below). To do this simply tie a guy line (not supplied) to the
webbing loop located by the base of the upright strap (shown as guy1 on image 1 below), then pass
the guy line through the webbing loop located at the top of the tunnel (shown as guy2 on image 1
below).
• Then pull the guy line over the top of your vehicle and peg it into the ground on the opposite side of
your vehicle (as shown in image 4).
• This will then pull the fabric up and towards your vehicle as
shown in image 3 below.
image 4
image 3
image 2
image 1
guy1
guy2