Page: 4
A5505
Screen House Pro Vehicle Connector Full Instructions
Page: 5
A5505
Screen House Pro Vehicle Connector Full Instructions
Fitting - Connecting the tunnel
How to fit the vehicle connector.
To fit your vehicle connector, you first fit the connector to your screen house and then the connector
to your vehicle. Our recommended way is listed below.
Attaching the connector to the Screen House
• First locate the dual zips on the outer edge of the connector. If you are connecting it to a Screen
House 4 Pro then remove the adapter zip on the connector as this is only used when connecting to a
Screen House 6 pro.
• If you are connecting it to a Screen House 4 Pro you use the inner of the two zips. For a Screen House
6 Pro you connect it to the adapter zip on the outer zip.
• Once the connector is fulled zipped on, you then connect the connector to your vehicle.
Connecting to your Vehicle
• Next move the Screen House and connector to your vehicle and connect the connector, using the
method of your choice. See the connection methods listed on the following pages for more details on
the options you have.
• IMPORTANT
: If you are connecting to a Screen House 4 pro then make sure the roof zips are open
(unzipped) as these are open for the Screen House 4 pro and closed when using with the Screen
House 6 pro.
• Once connected you put the tunnel pole in place and peg.
Tunnel Pole and Pegging
• Next you put the tunnel pole in place. The connector comes with two poles. The longer of the two is
used with the Screen House 4 pro and the shorter of the two poles is used with the Screen House 6
pro.
• Put the pole together and place in the tunnel. There is a pocket for the pole at the bottom of each
side of the tunnel.
• When the pole is in place ensure the Velcro tie backs are all in place as this holds the pole in place
and forms the curved roof to push rain water off.
• Next peg the rear floor pegging point of the tunnel just underneath your vehicle. We have found that
if you are connecting it to a VW transporter with a roll out canopy on, we recommend pegging the
right hand side just in front of the vehicle and not underneath it as this allows a small gap to ensure
if your sliding side door is opened too quickly it does not damage the vehicle connector.
• Then pull the Screen House away from the vehicle until the tunnel sides and roof become tight. This
is then the correct position to peg the tunnel and Screen House.
• The last stage is adjusting the tunnel to the best fit possible.
continued overleaf