QD. TRINST1supp.PM6 iss.7/GJ-06/09
6
Stem Angle Adjustment
Adjusting the angle of the stem determines how close the handlebars
are to the user. By considering the angle of the handlebars, the angle
of the stem and the height of the stem, the optimum handle bar
position can be achieved.
To adjust the angle of the stem, locate the single socket-head bolt
on the underside of the stem. Undo this bolt so that the plate it
holds in place moves freely. Adjust the stem to the desired angle
and tighten the bolt. The end of the plate will fit into one of the
grooves on the underside of the stem. Ensure the plate locks firmly
into one of the grooves and fully tighten the bolt. Adjust the height
of the stem and the angle of the handlebars to further fine-tune the
handlebar position.
Ensure all bolts are firmly tightened before the trike is used.
This device stops the front wheel from ‘jack-
knifing’ and is a critical safety feature and must
be engaged when the user is on the trike.
Once the handlebars have been set up ensure
the limiter is in position by turning the black
knob to the location show in fig.1. Lock the
limiter into place by tightening the white plastic
nut against the trike frame. Check the handle
bar movement is now restricted.
*Earlier models featured a hex-bolt and nut.
Steering Limiter
(2009-onwards)
!
Critical
Safety
Feature
Quest 88 limited, Aston Street, Shifnal, Shropshire, TF11 8DW
tel: +44 (0)1952 463050 fax: +44 (0)1952 463077 www.quest88.com email:[email protected]