16
7.3 Resetting
This section explains how to perform a general reset on a Q2300W
alarm. This restores the unit to when it was first powered up. This
procedure can also remove a unit from a network.
Follow the steps below to resolve any of these situations:
* If you have problems connecting the Q2300W alarm to a wireless
network.
* If a Q2300W is consistently out of range, and needs to be removed
from the wireless network.
* If you decide to transfer a Q2300W from your network to another
wireless network.
User Input
Detector Response
Timeout
Step 1
Press the RF button.
The unit will enter Join
Mode and flash its Amber
LED either:
(1) Twice every 2 seconds -
denotes Host
(2) Three times every 2
seconds - denotes Peer
OR (3) 1 second ON, then
1 second OFF - denotes
Network Search.
Step 2
Press and hold its
RF button for 4 to 5
seconds to reset the
Q2300W
unit.
The Amber LED will blink
four times, which is
repeated, to indicate the unit
has been reset. It is now in
standalone mode, and is not
part of any network until its
RF button is pressed twice
to re-enter Join Mode.
Step 3
Press the RF button
twice on any other
wireless unit to
close the Join Mode.
Amber LED on each unit
will power off indicating
Standby Mode
Step 4
To re-join a network,
please start over
with Section 7.2
If any issues occur,
please call Technical
Support.
