4
Assembly and Installation
Introduction
This assembly installation procedure provides a baseline procedure that will reliable install the unit.
With experience you may find more efficient methods of installation. Always verify changes and/or
alternate methods of assembly and installing the unit with the Precor Queenax product installation
department.
IMPORTANT
: Always verify any procedural changes or alternative methods to this installation
procedure with the Precor Queenax installation department.
Before starting make sure you have reviewed and completed all tasks listed in the Getting Started sec-
tion, see
"Getting Started" on page 7
.
IMPORTANT
: Review the Getting Started section (see
"Getting Started" on page 7
) and
adhere to safety information before starting the assembly and installation process.
Procedure
Prepare Towers for installation
1. Unpack and lay the three beam section 250 assemblies on the floor as close as possible to the
install location. Refer to the rendering for specific part location and attachment information.
2. Attach the strap rack to the tower terminal 35 cm side using a 6 mm hex key to secure the M10
hex key bolt, M10 flat washer, and M10 nut. Fully tighten fasteners and torque to 34 ft-lbs (46
Nm).
9
4 Assembly and Installation
Introduction
