QUBINO ZMNHWD1, User Manual

Page: 36 / 53

EN .
36
BRIGHTNESS MODE:
All outputs are controlled together, i.e. one switch controls brightness of all channels at the
same time.
1. Momentary switch type
INx (for orientation this function is set on IN1 by default)
•
Fast press on input INx (less than 1 second) -> turn the Q1, Q2, Q3, Q4 brightness to the
“last non zero value”
o
Dimming time depends on Parameter no. 12 value.
•
Fast press on INx -> turn Q1, Q2, Q3, Q4 brightness OFF
o
Dimming time depends on Parameter no. 12 value.
•
Press and hold (more than 1 second) -> increase brightness on Q1, Q2, Q3, Q4 and set
new “last non zero value” for Q1, Q2, Q3, Q4
o
Dimming time depends on Parameter no. 13 value.
•
Press and hold (more than 1 second) -> decrease brightness on Q1, Q2, Q3, Q4 ->
decre ase brightness on Q1, Q2, Q3, Q4 and set new “last non zero value” for Q1, Q2,
Q3, Q4
o
Dimming time depends on Parameter no. 13 value.
•
Fast double click - > turn the Q1, Q2, Q3, Q4 brightness to “MAX dimming value”
o
Dimming time depends on Parameter no. 12 value.
2. Toggle switch type
INx
•
Switch position -> turn the Q1, Q2, Q3, Q4 brightness OFF
o
Dimming time depends on Parameter no. 12 value.
•
Switch position - > turn the Q1, Q2, Q3, Q4 brightness to “MAX dimming value”
o
Dimming time depends on Parameter no. 12 value.
3. Toggle with memory switch type
Example: If the motion sensor turns on the light and then the user turns it off via the app, when
the negative impulse comes from motion sensor, the light should not turn on again.
INx
•
Position 1 to Position 2 - > turn the Q1, Q2, Q3, Q4 to “MAX dimming value”
o
Dimming time depends on Parameter no. 12 value.
•
Position 2 to Position 1 -> turn the Q1, Q2, Q3, Q4 OFF
o
Dimming time depends on Parameter no. 12 value.