EN
.
31
11. Removing the device from a Z-Wave network
(Exclusion)
REMOVAL FROM A ZWAVE NETWORK (Z-WAVE EXCLUSION)
1. Connect the device to the power supply
2. Make sure the device is within direct range of your Z-Wave gateway (hub) or use a hand-
held Z-Wave remote to perform exclusion
3. Enable add/remove mode on your Z-Wave gateway (hub)
4. Press and release the S button 3 times within 2 seconds
5. After exclusion device will automatically attempt to re-include in the next 2 minutes.
6. The device will be removed from your network but any custom configuration parameters
will not be erased
FACTORY RESET
1. Connect the device to the power supply.
2. Press and hold the S (Service) button for more than 10 seconds (the white blink on LED strip,
signal that the device is reset now you can release the S button)
3. After the factory reset device will automatically attempt to re-include in the next 2 minutes.
ⓘ
By resetting the device, all custom parameters previously set on the device will return to
their default values, and the owner ID will be deleted. Use this reset procedure only when the
main gateway (hub) is missing or otherwise inoperable.
Summary of Contents for ZMNHWD1
Page 10: ...EN 10 Remotely dim up to 4 LED bulbs or turn them ON OFF ...
Page 16: ...EN 16 4 Package Contents Flush RGBW Dimmer Device Installation Manual ...
Page 22: ...EN 22 After Qubino installation ...
Page 23: ...EN 23 INSTALLATION EXAMPLE Controlling four halogen or LED lights ...
