QUBINO ZMNHDD2, User Manuals

Page: 45 / 70

EN .
45
11. Removing the device from a Z-Wave network
(Exclusion)
REMOVAL FROM A ZWAVE NETWORK (Z-WAVE EXCLUSION)
1. Connect the device to the power supply
2. Make sure the device is within direct range of your Z-Wave gateway (hub) or use a hand-
held Z-Wave remote to perform exclusion
3. Enable add/remove mode on your Z-Wave gateway (hub)
4. Toggle the switch connected to the I1 terminal 3 times within 3 seconds
OR
If the device is powered by 24 V SELV supply, press and hold the S (Service) button between 2
and 6 seconds
5. The device will be removed from your network but any custom configuration parameters
will not be erased
FACTORY RESET
1. Connect the device to the power supply
2. Within the first minute (60 seconds) the device is connected to the power supply, toggle the
switch connected to the I1 terminal 5 times within 3 seconds (5 times change switch state).
OR
If the device is powered by 24 V SELV supply, press and hold the S (Service) button for at least 6
seconds
ⓘ
By resetting the device, all custom parameters previously set on the device will return to
their default values, and the owner ID will be deleted. Use this reset procedure only when the
main gateway (hub) is missing or otherwise inoperable.